retroforth/doc/papers/Notes_on_Metacompilation_and_Assembly.txt
crc ab027a48a7 check in some short articles on design and reflections on historic retro systems
FossilOrigin-Name: eb357b5905393a162430aaaa4f8d4c3803a060ee6715e899efa3d3973a6bdc1e
2019-01-31 13:08:25 +00:00

77 lines
2.8 KiB
Text

Retro 10 and 11 were written in themselves using a metacompiler.
I had been fascinated by this idea for a long time and was able
to explore it heavily. While I still find it to be a good idea,
the way I ended up doing it was problematic.
The biggest issue I faced was that I wanted to do this in one
step, where loading the Retro source would create a new image
in place of the old one, switch to the new one, and then load
the higher level parts of the language over this. In retrospect,
this was a really bad idea.
My earlier design for Retro was very flexible. I allowed almost
everything to be swapped out or extended at any time. This made
it extremely easy to customize the language and environment, but
made it crucial to keep track of what was in memory and what had
been patched so that the metacompiler wouldn't refer to anything
in the old image during the relocation and control change. It
was far too easy to make a mistake, discover that elements of
the new image were broken, and the have to go and revert many
changes to try to figure out what went wrong.
This was also complicated by the fact that I built new images
as I worked, and, while a new image could be built from the last
built one, it wasn't always possible to build a new image from
the prior release version. (Actually, it was often worse - I
failed to check in every change as I went, so often even the
prior commits couldn't rebuild the latest images).
For Retro 12 I wanted to avoid this problem, so I decided to go
back to writing the kernel ("Rx") in assembly. I actually wrote
a Machine Forth dialect to generate the initial assembly, before
eventually hand tuning the final results to its current state.
I could (and likely will eventually) write the assembler in
Retro, but the current one is in C, and is built as part of the
standard toolchain.
My VM actually has two assemblers. The older one is Naje. This
was intended to be fairly friendly to work with, and handles
many of the details of packing instructions for the user. Here
is an example of a small program in it:
:square
dup
mul
ret
:main
lit 35
lit &square
call
lit &square
call
end
The other assembler is Muri. This is a far more minimalistic
assembler, but I've actually grown to prefer it. The above
example in Muri would become:
i liju....
r main
: square
i dumure..
: main
i lilica..
d 35
r square
i en......
In Muri, each instruction is reduced to two characters, and the
bundlings are listed as part of an instruction bundle (lines
starting with `i`). This is less readable if you aren't very
familiar with Nga's assembly and packing rules, but allows a
very quick, efficient way of writing assembly for those who are.
I eventually rewrote the kernel in the Muri style as it's what
I prefer, and since there's not much need to make changes in it.